Free On-Line Electrical Books

Assemble your own copy - see Instructions below.

Published by Kilowatt Classroom Electrical Training Seminars

Note: You will need Adobe Acrobat Reader to view and download the Notebook Setup Files and the Electricians Notebook ^TM Article Files.  If you do not have the Acrobat Reader Program click the link above to download a free copy from their site.

To view a listing of back Electricians Notebook ^TM articles and TPI Instrument Application Notes click Archive Catalog.
 

Insert the above information in Section 2 of your Industrial Electricians Notebook ^TM

Written and Compiled by

 Elwood V. Gilliland

© 2004 Kilowatt Classroom, LLC.

This material is used here by permission of the author and in the following
Kilowatt Classroom Electrical Training Seminars:

Industrial Electrical Systems

Basic Industrial Electronics
 

The Industrial Electrician’s Notebook ^TM

© 2002 - 2006 Kilowatt Classroom, LLC.

Published by

Kilowatt Classroom, LLC.

Electric Power Training for Industry

9267 Red Creek Road, Casper, Wyoming 82601

www.kilowattclassroom.com

The Information contained in The Industrial Electricians Notebook ^TM and the TPI Instrument Application Notes,  is made available free-of-charge at www.kilowattclassroom.com and is for personal use only.  All rights reserved.  Reproduction or use without express permission, of editorial or pictorial content in any manner, is prohibited.  While every precaution has been taken in the preparation of this material, the publisher assumes no responsibility for errors or omissions.  Neither is any liability assumed for damages or injury resulting from the use of the information contained herein.

The Electrician's Notebook and The Industrial Electrician's Notebook are trademarks of Kilowatt Classroom LLC.  The slogan "Interfacing Technology and Craftsmanship" is a trademark of Kilowatt Classroom LLC.  The SCR/PWM Waveform Logo is the service mark of Kilowatt Classroom LLC.

How to Set-up Your Notebook - It’s Easy

Supplies You Will Need

These few, inexpensive, supplies are readily available at most office and stationery supply stores and are all that is required to assemble your own copy of The Industrial Electricians Notebook ^TM. A 1” capacity, three-ring, notebook with a protective clear cover (such as the Avery View or the Wilson Jones Clean View), an Avery Easy Edit, 8-Tab,Table of Contents Divider set (Avery Catalog # 11172) or Avery Ready Index, 8-Tab, Table of Contents Dividers (Avery Catalog # 11133), and a few clear 8-1/2’ X 11” page protectors.

Assembling Your Notebook

To set-up your copy of The Industrial Electricians Notebook ^TM, our free online electrical books selection, click Setup Files link to view, download, and print the notebook Cover Sheet and Spine Label, the Title and Preface pages, and the Table of Contents pages.  Insert the notebook Cover and the Spine Label behind the plastic area on the outside of the notebook (tip: the spine label is easier to insert if you open the notebook and lay it flat on a table to get some slack in the plastic.  It also helps to print the spine label on paper that is slightly heaver than the usual 20 lb stock.). Put the Title Page and Preface Page back-to-back and insert them into a page protector. Place the Table of Contents Pages 1 & 2 back-to-back and insert them into the Avery Easy Edit contents page.